Sekonic L-508 CINE ZOOM MASTER Manual de instrucciones descargar pdf (Pagina 6)

4. Basic Operation

2. Setting measuring mode

• Hold down the Mode set button 10 and turn the

Set/change dial 5 to select the desired mode. The mode

switching sequence is shown in the chart below:

4. Basic Operation

3. Setting DIP Switches

•Switches for setting modes that are used infrequently are housed in the Battery compartment

23 of the meter. Select the mode you want prior to beginning measurements.

•The DIP switches can be set by sliding the DIP switch 22 for the mode you want to select in the

ON position.

* TIME 0.5

If DIP switch 1 is ON, the shutter speed will be displayed in half steps.

If DIP switch 1 is OFF, the shutter speed is displayed in full steps.

* F NO.

If DIP switch 2 is ON, Aperture Priority mode (ambient light) can be set.

* EV

If DIP switch 3 is ON, EV (exposure value) mode (ambient light) can be set.

* MULTI

If DIP switch 4 is ON, Multiple Flash mode (cumulative) can be set.

4. When set for Incident light

• Measurement of incident light uses Lumisphere or recessed Lumisphere. You can switch

between Lumisphere and recessed function by firmly rotating the Lumisphere UP/DOWN ring 1

until it clicks.

•When the Lumisphere is raised

This is used to photograph people, buildings, and other three dimensional objects.

•When the Lumisphere is lowered (flat diffuser function)

This is used to photograph manuscripts, paintings or other flat copy. It can also be used for

measuring illumination contrast (see page 20) or illumination levels (see page 22), or brightness

difference (see page 20).

NOTE:

•If the device is used with the UP/DOWN ring in a middle position, distributed light quality

will change, and suitable measurements cannot be made.

•

Do not push the Lumisphere down manually.

-8-

-7-

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sin comentarios

Sekonic L-508 CINE ZOOM MASTER Manual de instrucciones Pagina 6